环氧树脂面漆汇.docVIP

Intended Uses 用途用于厚膜环氧系列上,作为水泥,混凝土等表面的面漆,耐溅泼的弱酸,弱碱盐类或溶剂及蒸汽. Applied to high build epoxy system. As finish Used for surface of cement etc. Resistant to spattering of weak acid,weak alkali, salt, solvents and thier vapours . Product Information产品简介高性能,两罐装,环氧树脂面漆,无空气喷涂,涂膜坚韧,耐磨,颜色可选择. High-performance, two packages, Epoxy resin finish, suitable for airless spary. Tough, resistant to war,Color for selection. Application details 产品数据Volume Solids 固体份≥50%Dry Flm Thickness干膜厚度50 microns equivalent to 100 microns of wet film 50微米相当于100微米湿膜厚Theoretical Coverage 理论涂布率7.3-8.9m2 /Kg at the stipulated volume solids and 50 microns of dry film thicness 7.3-8.9平方米/公斤,以规定体积固体份和50微米湿膜厚计Practical Coverage 实际涂布率Allow appropriate loss 允许适量损耗Storage and Handling 施工详述 Mix Radio 混合比A : B=5:1(by weight) 甲:乙=5:1（重量比）Method of Application 施工方法 Airless Spray 无空气喷涂 Recommended 推荐采用 Brush or Roller 涂刷或辊涂 Suitable only for small area 仅适用于小面积 Conwentional Spray 传统喷涂 Suitable, but dilution is required 适用，需稀释 Thinner 稀释剂 Not necessary in normal 正常情况不需要Cleaner 油漆设备清洗剂 SC003Pot Life 使用期 25℃:6h 25℃6小时 Storage 贮存期 One year 一年Drying time 干燥时间 Substrate Temperature 底材温度Touch Dry 表干 （h）Hard Dry 硬干 (h）Over coating Interval 覆涂间隔Min最短Max最长25℃42424 hours 小时 7days (天) 环氧树脂面漆(双组份) Storageand Handling 贮存与管理Storage 贮存 Store in cool and dry conditions 贮存于阴凉干燥处 Pack size 包装规格 A;20Kg in 20 liter container 甲:20公斤装于20公升容器中 B:4Kg in 4 liter container 乙:4公斤装于4公升容器中Flash Point 闪点 A