LeCroy AP015手册--附带校准方法.pdfVIP

AP015 Current Probe Instruction Manual WOE-CS-TS02-009v002 1/111 Specifications The following specifications are valid for model AP015 current probes after the probe has reached operating temperature, which is 20 minutes with power applied in a environment with stable ambient temperature. The probe must be operating within the environmental conditions listed in the General Characteristics section, and has been calibrated within the past 12 months in a ambient temperature of 23 ±5 o C. Nominal Characteristics Nominal characteristics describe parameters and attributes which are guaranteed by design, but do not have associated tolerances. INTERFACE: PROBUS COUPLING: AC, GND, DC MAXIMUM CURRENT, DC±30A (CONTINUOUS) ±50A MAXIMUM (10S) SENSITIVITY: 10 MA/DIV – 20 A/DIV OFFSET RANGE ±100A MAXIMUM MAXIMUM CONDUCTOR SIZE 5 MM MAXIMUM VOLTAGE, BARE CONDUCTOR 300 V CAT I 150 V CAT II CABLE LENGTH 2 M WEIGHT, PROBE ONLY300 G (10.6 OZ.) Warranted Electrical Characteristics Warranted characteristics describe parameters which have guaranteed performance. Unless otherwise noted, tests are provided in the Performance Verification Procedure for all warranted specifications. DC ACCURACY:±1% OF READING TO 15A (AT 25O C, AFTER DEGAUSS) ±2% OF READING TO 30A (AT 25O C, AFTER DEGAUSS) BANDWIDTH DC TO 50MHZ Typical Electrical Characteristics Typical characteristics describe parameters which do not have guaranteed performance, however are representative of the average performance from a sample of several probes. Tests for typical characteristics are not provided in the Performance Verification Procedure. AP015 Current Probe Instruction Manual WOE-CS-TS02-009v002 2/111 RISE TIME: 7 NS SLEW RATE 1.6 A/NS ( SENSITIVITY ≥ 1 A/DIV) INSERTION IMPEDANCE 0.06? AT 5 MHZ General Characteristics TEMPERATURE: 0 – 40 O C OPERATING RELATIVE HUMIDITY80% MAXIMUM UP TO 31O C USAGE ENVIRONMENT INDOOR ALTITUDE 2000 M MAXIMUM POWER REQUIREMENTS:POWERED