G1_WS71-2DPipeJunctionV12.pdfVIP

Chapter 7 Introduction to Hexa – Workshop 7.1 2D Pipe Junction Introduction to ANSYS ICEM CFD WS7.1-1 ANSYS, Inc. Proprietary ? 2010 ANSYS, Inc. All rights reserved. Release 12.0 January 2010 Introduction to Hexa – Workshop 7.1 Training Manual Hexa Workshop 1 2D Pipe Junction WS7.1-2 ANSYS, Inc. Proprietary ? 2010 ANSYS, Inc. All rights reserved. Release 12.0 January 2010 Introduction to Hexa – Workshop 7.1 Training ManualCreate a Project Create the project – File New Project – Browse to the working directory (2DPipeJunct) – The pull down next to the – Enter the project name (2DPipeProject) – Save (it will append .prj if this extension is not already there) file name can be used to quickly locate recently used projects. The Project file contains– information about project settings, the working folder and file associations. – After saving project, simply loading the project file will load all WS7.1-3 ANSYS, Inc. Proprietary ? 2010 ANSYS, Inc. All rights reserved. Release 12.0 January 2010 associated files within working directory Introduction to Hexa – Workshop 7.1 Training ManualOpen Geometry Open geometry – File Geometry Open Geometry Choose “geometry tin”– . – Open WS7.1-4 ANSYS, Inc. Proprietary ? 2010 ANSYS, Inc. All rights reserved. Release 12.0 January 2010 Introduction to Hexa – Workshop 7.1 Training ManualInitialize Blocking #1 Begin blocking – Select Blocking Create Block Initialize Blocks – Change TYPE to 2D Planar – Apply – This creates one block #2 #3 which encloses the entire geometry – Curves automatically change color (colored separately instead of by part) to allow you to see where the ends of curves are#4 WS7.1-5 ANSYS, Inc. Proprietary ? 2010 ANSYS, Inc. All rights reserved. Release 12.0 January 2010 Introduction to Hexa – Workshop 7.1 Training ManualSplit to Create Topology U d l i t l i “T” h d? n er y ng opo ogy s s ape – This concept is initially difficult for many new users, but thinking “how do I