VALVESISO55991,SERIESIPV-ISV.PDFVIP

1VALVES ISO 5599/1, SERIES IPV-ISV The assembly surface dimensions of ISO1, ISO2 and ISO 3 valves are to ISO5599-1. They are available in the 5-way versions with 2 and 3 positions and with pneumatic or solenoid actuation. Filtered air without lubrication; lubrication, if used, must be continuous Vacuum ÷10 bar pneumatic – 2.5÷10 bar solenoid/pneumatic Vacuum ÷ 10 bar pneumatic – 1÷10 bar solenoid/pneumatic Vacuum ÷ 10 bar 2.5 bar -10°÷ +60°C 7.5 mm 12 mm 15 mm 250 Nl/min · bar 657.14 Nl/min · bar 971.43 Nl/min · bar 0.36 bar/bar 0.25 bar/bar 0.43 bar/bar 700 Nl/min 1800 Nl/min 3200 Nl/min 1100 Nl/min 2700 Nl/min 4600 Nl/min In any position (vertical assembly is not recommended for bistable valves subjected to vibration) On single and manifold bases according to ISO 5599/1 ISO and UNI FD 22 to CNOMO / in-line pilot / M12 to CNOMO bistable on solenoid pilot monostable on valve body 1 Nm see GENERAL CATALOGUE page 6.1/08 or webpage www.metalwork.it/eng/materiali_compatibilita.html TECHNICAL DATA Fluid Operating pressure: ? monostable ? bistable ? pilot-assisted Minimum pilot pressure Operating temperature range Nominal diameter Conductance C Critical ratio b Flow rate at 6 Bar ΔP 0.5 Bar Flow rate at 6 Bar ΔP 1 Bar Installation Assembly Recommended lubricant Solenoid pilot: Manual: Maximum torque nut/coil Compatibility with oils: COMPONENTS  VALVE BODY: Aluminium  END CAP: HOSTAFORM?  SPOOL: chemically nickel-plated aluminium  DISTANCE PLATES: plastic  GASKETS: NBR nitrile rubber  PISTONS: HOSTAFORM?  PISTON GASKETS: NBR nitrile rubber FILTER: sintered bronze SPRINGS: special steel  OPERATOR: Brass pipe – Stainless steel core ISO 1 ISO 3ISO 2 2FLOW CHARTS ISO 1 KEY TO CODES I P V IPV ISO pneumatic ISV ISO solenoid/ pneumatic FAMILY 5 5 ISO 1 6 ISO 2 7 ISO 3 PORT P N PN pneumatic SO solenoid/pneumatic SE electric pilot-assisted  DO solenoid/pneumatic in line  DE solenoid, assisted in line  CO M12 solenoid/pneumatic  CE M12 solenoid assisted OPERATORS 1