台达DVP02DA-04DA.pdfVIP

DVP-1130230-01 5011686000-E2G0 2009-06-22 - 1 - ENGLISH Thank you for choosing Delta’s DVP series PLC. DVP02DA-E2 (DVP04DA-E2) analog output module receives 2 (4) groups of 16-bit digital data from the PLC MPU and converts the digital data into 2 (4) points analog output signals (voltage or current). In addition, you can access the data in the module by applying FROM/TO instructions or write the output value of channels directly by using MOV instruction (Please refer to allocation of special registers D9900 ~ D9999). This instruction sheet provides only information on the electrical specification, general functions, installation and wiring. For detailed program design and applicable instructions, please refer to “DVP-ES2 Operation Manual: Modules”. For details of the optional peripheral, please refer to the instruction sheet enclosed in it. This is an OPEN TYPE I/O module and therefore should be installed in an enclosure free of airborne dust, humidity, electric shock and vibration. The enclosure should prevent non-maintenance staff from operating the device (e.g. key or specific tools are required for operating the enclosure) in case danger and damage on the device may occur. DO NOT connect the input AC power supply to any of the I/O terminals; otherwise serious damage may occur. Check all the wiring again before switching on the power. Make sure the ground terminal is correctly grounded in order to prevent electromagnetic interference. Product Profile Dimension Removable I /O terminal Direct mounting hole Mounting slot (35mm) Power / D-A / Error indicators I/O module connection port I/O terminal No. Model Name I/O module cl ip [ Figure 1 ]I/O module connection port 02DA-E2 2AO [ Figure 2 ]70 62 10 698 78 90 61.5 11 0 Unit: mm - 2 - External Wiring VO1 IO1 AG VO4 IO4 AG 0V 24V DC/DC +15V -15V AG FE FE CH1 CH1 Isolation wire*1 -10V~+10V*2 *3 0mA~20mA DC24V CH4 CH4 [ Figure 3 ] Voltage output AC drive, recorder, scale value... AC drive,