中国国际贸易中心三期a阶段工程之设计、供应及安装玻璃幕墙工程塔冠幕墙结构计算书_毕业论文.doc

中国国际贸易中心三期A阶段工程 China World Trade Center Phase 3A 之设计、供应及安装玻璃幕墙工程 Facade Scope of Work 塔冠幕墙结构计算书 Structural Calculation for curtain wall on tower crown 编制人AUTHOR： 版号REV ： B 编制单位：JIANGHE GROUP 编制日期：September 28, 2007 Catalogue 说明 notes 2 PART Ⅰ：玻璃幕墙计算 calculation on glass C.W. 4 1 荷载计算Load calculation 4 2 玻璃面板计算Glass panel calculation 9 3 中横料计算Calculation for middle transom 18 4 单元横料计算Calculation for transom 23 5 单元竖料计算calculation for mullion 29 6 单元边立柱计算 Unit mullion calculating 45 7 竖料插芯计算Calculation for plugboard in mullion 51 8 挂件组计算calculation for bracket group 65 9 层间附加钢梁计算Calculation for spandrel steel beam 79 PART Ⅱ：铝板结构计算Calculation for Alum panel Structure 101 10 荷载计算Load calculation 101 11 铝板计算Calculation for alum panel 103 12 钢立柱计算calculation for steel mullion 113 PART Ⅲ：玻璃翼计算Calculation for Glass fin 117 13 玻璃计算Glass calculation 117 说明 notes 本工程计算采用的风荷载，根据国家规范计算和风洞试验结果进行比较，取较大值。大楼标高330m，根据中国规范《建筑结构荷载规范GB 50009—2001》计算出的风荷载标准值为4.1 KPa。根据业主提供的风洞试验报告，最大风荷载位于大楼东立面26层，标高110.6m，其风荷载标准值为3.3 KPa。所以塔冠结构计算时取4.1KPa。 The larger one of the wind load value calculated per national code and result from wind tunnel test will be used in this calculation. The height of tower is 330m. The characteristic value of wind load calculated according to the ?Load Code for the Design of Building Structures GB50009-2001? is 4.1 KPa, while per the wind tunnel test provided by Owner, the Max wind load is on the L26 of the eastern fa?ade, 110.6m high, whose characteristic value for the wind load is 3.3 KPa Therefore 4.1KPa is adopted when conducting the structural calculation for the hotel floor. 玻璃翼风荷载按照风洞试验报告最大值选取，其风荷载标准值为8.25 KPa。 the Max value 8.25 KPa of wind tunnel test is adopted for the wind load on glass fins. PART Ⅰ：玻璃幕墙计算 calculation on glass C.W. 1 荷载计算Load calculation 1.1 幕墙自重荷载计算Dead load calculation for curtain wall 玻璃重力密度Gravity density of glass: 25.6 KN/m3 铝材重力密度Gravity density of Aluminium: 28 KN/m3 10+12A+8