Windows Embedded Boot Camp.pptVIP

Windows Embedded Boot Camp Building a Recovery CD Building a Recovery CD In this session we are going to cover the steps that are needed to create a recovery CD Steps to Create the Recovery CD Steps to Create the Recovery CD Steps to Create the Recovery CD Steps to Create the Recovery CD Steps to Create the Recovery CD Steps to Create the Recovery CD Modifications in WINNT.SIF [DATA] AutoPartition = 1 This will partition your HDD like WINBOM.INI does when using Setup Manager MsDosInitiated = 0 This will inform Windows Setup that it is running from the CD UnattendedInstall = Yes This will inform Windows Setup that it is running from the CD [UNATTENDED] OEMPreinstall = Yes This will pickup the $OEM$ dir on the CD Factory Mode = Yes After Windows Setup completes, SysPrep runs and access the WINBOM.INI OEMPnPDriversPath = SySPrep\OEMDrivers\Storage; This will load Mass Storage and Net drivers like “F6”; if needed for boot support. See OPK Guide for details Repartition = Yes Creates only 1 partition on the HDD and formats with NTFS [USERDATA] ProductKey = xxxx-xxxx-xxxx-xxxx-xxxx Populate OEM or SLP product key for unattended install Steps to Create the Recovery CD Steps to Create the Recovery CD Modifications in WINBOM.INI [FACTORY] Resealmode = OOBE Preps the system for Windows Welcome Reseal = Reboot Reboots the computer into Windows Welcome for the customer [COMPUTERSETTINGS] AuditAdminAutoLogon = Yes Specifies if the Admin logs on during Factory Mode [PNPDrivers] C:\SysPrep\OEMDRIVERS\ = OEMDrivers This will copy all drivers from the specified path to “C:\Windows\Drivers\OEMDrivers” and then install them [PNPDRIVERUPDATE] DevicePath = C:\SysPrep\OEMDRIVERS\ Points to OEM Drivers to install UpdateInstalledDrivers = Yes Calls PnP after all drivers are installed and only updates all installed drivers (if necessary) WaitForPnP = Yes Waits for Windows to enumerate all devices before installing drivers [OEMRUNONCE] Installing QFE 3