SU4Rev410-07STARTUPSuperPhobic1x4and2x6Chinese.pdfVIP

储存和操作说明 ? 膜元件 您所购买的SuperPhobic? 脱气膜组件会因不当操作和存储而受到损害。以下是脱气 膜组件的正确保存的导则框架。若您有任何的疑问，请您和当地的MEMBRANA 代表 联络。 .处置：正确的处置膜组件是很关键的。必须注意不要碰撞和震动膜组件以把造成膜内 部损坏的可能性降低到最小程度。组件的三个接口要塞紧，以防止污染物进入膜组件 内。建议膜组件储存在一个干燥、热密封的塑料袋中或储存在有热缩塑料包的材料制 成的厚0.076mm （0.003 英寸）的原始包装袋中。 温度：膜组件储存在它的干燥的原包装中温度不要超过 49 ℃(120o F)。如果膜组件储 存在环境温度低于5℃时，则应预先使元件平衡至室温，然后方可进水。 湿度：建议膜组件在低到中等的湿度下储存（﹤60%相对湿度）。 曝光：膜组件不能保存在有光线直接照射到的地方，同时它必须总是储存在隔热密封 袋中或热缩塑料包材质制成的原始包装盒中或不透明的盒子中。 Manufactured with Sound Engineering Practice per Article 3, paragraph 3 of 97/23/EC. 1x4 和2 x 6 辐流式膜元件开机步骤 ISO 9001:2000 ISO 14001:2004 This product is to be used only by persons familiar with its use. It must be maintained within the stated limitations. All sales are subject to Seller’s terms and conditions. Purchaser assumes all responsibility for the suitability and fitness for use as well as for the protection of the environment and for health and safety involving this product. Seller reserves the right to modify this document without prior notice. Check with your representative to verify the latest update. To the best of our knowledge the information contained herein is accurate. However, neither Seller nor any of its affiliates assumes any liability whatsoever for the accuracy or completeness of the information contained herein. Final determination of the suitability of any material and whether there is any infringement of patents, trademarks, or copyrights is the sole responsibility of the user. Users of any substance should satisfy themselves by independent investigation that the