HIGHSPEEDBUFFINGMACHINE高速抛光机..docVIP

Operation sequence操作程序 Let the trailing wheel touchdown, lean back the buffing machine until the handle touch the floor. 让后轮着地，向后倾斜抛光机，直至手柄放在地上；Counterclockwise rotate out the locked screw in the yellow center. 逆时针旋转出黄色中心锁紧螺钉；Place the polishing pad steadily on the driver, and screw tightly the bolt in the yellow center. 把所需的抛光垫安放在抛光垫驱动器上，拧紧黄色中心锁紧螺钉；Restore the high speed buffing machine until it stands erectly. 将高速抛光机恢复至直立位置；Lift the relaxing handle bar and put down the handle, which make the head of the buffing machine float freely up and down. 提起手柄放松杆，放下手柄，使抛光机头可上下自由浮动。Connect the electricity line with the plug which connects with the grounding line, and put through the power supply. 将电源线插入有接地线的插座上，接通电源。 Press down the safety lock button, and rotate forwards the revolving handle, and start the high speed buffing machine. When the machine works, leave the thumb out of the safe locked button. 按下安全锁定按钮，向前转动旋转手柄，开动高速抛光机。机器开动后，把拇指从安全锁定按钮上放开。 Impel the high speed buffing machine forward, or make it move with a “W” itinerary, start polish on the waxing layer of the floor, and it should keep the buffing machine moving, so as not to damage the wax layer and the floor board layer. 向前推动高速抛光机，或移动高速抛光机走“W”形，开始对地板打蜡层抛光。要使高速抛光机保持移动，以免损坏打蜡层和地板层面。In order to prevent the over loading of the motor, there is the protector matched to the electro circuit of the machine. If the breaker shut down, it should wait 15 seconds to make the machine reposition. 为了防止电动机过载，机器配有电路过载保护装置。断路器若断路，必须等待15秒钟后，方可使其复位。 In the end of the polishing work in the waxing layer of the floor board, rotate the revolving handle backwards; make the button of the safety lock separated, then the high speed buffing machine stop rotating. 地板打蜡层抛光结束，向后转动旋转手柄，安全锁定按钮脱开，高速抛光机停止转动。 When the work is finished, lean back the high speed buffing machine, with the trailing wheel touchdown, in order avoiding the damage of the polishing pad. Or unlade the pad to protect it. 工作完毕，保持高速抛光机向后倾斜，后轮着地，防止抛光垫损坏，或采取卸下抛光垫的方式保护抛