D型连接器规格.docVIP

Revision History Revision Revision Description PAGE Date B0 New release ALL 2009.10.16 1. SCOPE This specification is applied to the requirements for VGA,DVI connector .This specification covers the materials, electrical, mechanical and environmental performance of the applicable product description and test method. 2. REQUIREMENTS 2.1 Design and Construction Product shall be of the design, construction and physical dimensions specified on the Applicable product drawing. 2.2 Materials Refer to the drawing. 2.3 Related documents D-SUB：EIAJ RC-5237 2.4 Rating Item Standard Rated Voltage (Maximum) DC:12V Rated Current (Maximum) DC:1.0A Operating temperature range -25℃～+℃ 85%RH MAX Storage Temperature Range -40℃～+℃ 85%RH MAX 3. TEST STANDARD Unless otherwise specified, the standard range of atmospheric conditions for making measurements and tests are as follows 3.1 Ambient temperature: 5℃to35℃ 3.2 Relative humidity: 45% to 85% 3.3 Air pressure: 86Kpa to 106 Kpa 3.4 Test Requirements and Procedures Summary Item Test Condition/Method Requirement 1 Examination of Product Meets requirements of product drawing. No damage Electrical Performance 2 Contact Resistance Using mate plug and milli-ohm meter. JIS C5402-5.3 30 mΩ Max 3 Insulation Resistance 500VDC is applied between any contacts. JIS C5402-5.2 100MΩ Min 4 Withstanding voltage test Apply AC 500V at sea level on mated and Un-mated connectors for 1 minutes , while applying the voltage, the leakage current is monitored and shall be less than 2mA. JIS C5402-5.1 Appearance No damage/ deformation Dielectric withstanding voltage 500V（AC） Mechanical Performance 5 Connector Mating Force Operation Speed:25.4mm/min. Measure the force required to mate connector. JIS C5402-6.6 The test Mate Plug Ref to attachment (2) Mating force 50N Max 6 Connector Un-mating Force Operation Speed:25.4mm/min. Measure the forc