Photoshp打造完美虚线攻略.docVIP

Photoshop打造完美虚线攻略先看看虚线效果 键入一个字母“B”，并设定颜色为黄绿色 执行“图层文字创建工作路径”，此时路径调板中出现“工作路径” 在图层调板中新建图层，选择工具箱中的画笔工具，在画布上单击右键，即可弹出画笔的选项框，在选项框里设置画笔的主直径为2px，硬度为100％。 在回到路径调板中，将“[u]工作路径[/u]”向下拖曳到“用画笔描边路径”的按钮上，我拖了两次 下图就是描边的结果 使用放大工具，放大一些，为了是看清楚描边，使用矩形工具拖曳出一个矩形的选区，这个选区的大小要比你的描边略大一些，宽度既是虚线的间隔宽度。 填充成黑色 执行“编辑定义画笔预设”命令，在弹出的对话框中设定画笔的名称 单击“确定”按钮，完成画笔的定义，再按DEL键，将黑色的填充删除，再取消选择 在工具箱中选择橡皮擦工具，执行“窗口画笔”命令， 调出画笔调板，在画笔调板中选择上个步骤所定义的画笔，并将“间距”设定为350％ 将画笔调板中“形状动态”前的“√”选中，在“角度抖动”的“控制”后的下拉选项中选择“方向” 再次回到路径调板，将“路径”向下拖曳到“用画笔描边路径”的按钮上，即可用橡皮擦擦出虚线的效果 再将文字图层“B”显示，我降低了图层的不透明度 manufacturers drawings bolt fastened in the cylinder and outer cylinder. Cylinder cylinder in the drain pipe installation and measuring component leads. 6.4.4.3 blade carrier, partitions and lower installation check the sealing ring of the seal and springs, which shall conform to the technical requirements manufacturers drawings. Cylinder gasket on the mounting brackets supporting the Group assembled, the lugs shall be no Burr on the surface, and other debris. Department suite in place to measure surface and inner cylinder surface height difference, compared with the original values confirm the location. 6.4.4.4 lower bearing and thrust bearing installation clean bearing and bearing, thrust bearing joints, clean them with a thin layer of turbine oil, and then lifting it to bits. 6.4.4.5 high and middle pressure cylinder over it to the end (for high pressure rotor and low pressure change flange gasket without connection unit) rotors and rotor flange gasket connection and there is no connection, so the rotor in place cases, rotors in place must be high and middle pressure cylinder together with the Chamber over it to the end. Jack in the box that are installed on a push-pull device of adjusting the high and medium pressure cylinder to end over and around to set up indicators to monitor data, general data about the difference must not exceed 0.02mm. To prevent cylinder about out of sync over the situat