GEN2 Comfort New电梯调试培训_电气.pptVIP

4.3 变频器指示灯信息描述 * Status Green LED1 Yellow LED2 Red LED3 DSP is in Reset NOT FLASHING NOT FLASHING NOT FLASHING DSP is Running FLASHING ANY STATE ANY STATE Car Moving Up FLASHING FLASHING OFF Car Moving Down FLASHING ON OFF Events in Log FLASHING OFF FLASHING 4.4 变频器的故障响应方式 * Event Response Abbrev-iation Description INFO I The event is logged for information only and no action is taken by the drive. WARN W The event is logged for warning only and limited or no action is taken by the drive. COMP C The event is logged, the run is allowed to complete, and the drive enters the ShutDown state. The drive sets the Stop-an-Shutdown SAS flag until the fault condition clears. In CAN mode, the drive will NOT attempt another run until the fault condition clears. In MCSS mode, the drive will attempt another run if requested by the controller, except for thermal faults. NEXT-COMMITTABLE NC This response is applicable only for CAN–type controllers during normal runs. The event is logged and the target is changed to the next committable. PRS+LS signals are ignored for position corrections. The drive sets the stop and shutdown SAS flag until the fault condition clears. The run to the next committable will continue only if the fault is determined to be triggered by a failure of the GECB, a failure “both LS active” or a failure of the CAN communications. This is determined by checking if a follow-up event event “511 1LS 2LS !” was also logged or the CAN message “DrHwySignals” has timed out event “906 No LS Msg” . Otherwise, the fault response will transition to a timed decel DECEL . When the run ends, the drive passes through SHUTDOWN and position is invalidated. During other run modes than NORMAL, the fault reaction is an immediate timed deceleration DECEL . DECEL D This response is applicable only for CAN–type controllers. The event is logged, the run is terminated with a timed decel, and the drive enters the ShutDown state. The deceleration rate is 105% of co