iecen61010_1c报告.doc

TEST REPORT IEC 61010-1/ EN 61010-1 Safety requirements for electrical equipment for measurement, control, and laboratory usePart 1: General requirements Report Reference No. : Tested by (name and signature) : Approved by (name and signature) : Date of issue : Contents : 59 Pages Testing Laboratory : Address :  Testing location/procedure : CBTL [ ] SMT [ ] TMP [ ] Address :  Applicant’s name : Address :  Test specification: Standard : IEC 61010 – 1 : 2001 (2nd Edition); EN 61010 – 1 : 2001 (2nd Edition) Test procedure : CB / CCA Non-standard test method : — Test Report Form No. : IECEN61010_1C TRF Originator : VDE Master TRF : Dated 01-07-27 Copyright ? 2001 IEC System for Conformity Testing and Certification of Electrical Equipment (IECEE), Geneva, Switzerland. All rights reserved. This publication may be reproduced in whole or in part for non-commercial purposes as long as the IECEE is acknowledged as copyright owner and source of the material. IECEE takes no responsibility for and will not assume liability for damages resulting from the readers interpretation of the reproduced material due to its placement and context. Test item description : Trademark : Model/Type reference : Rating(s) :  Test item particulars : Type of item tested : Measurement / Control / Laboratory Description of equipment function :  Installation/overvoltage category : Pollution degree : Environmental rating : standard / extended (specify): Equipment mobility : portable / hand-held / floorstanding / fixed / built in Connection to mains supply : Permanent / detachable cord set / non detachable cord set / none Operating conditions : continuous / short-time / intermittent Overall size of the equipment (L x W x H) : Mass of the equipment (kg) : Marked degree of protection to IEC 60529 : Accessories and detachable parts included in the evaluation : Options :  Test case verdicts: Test case does not appl