《Cable Routing Procedures for》.pdfVIP

Cable Routing Procedures for Dell™ PowerEdge™ R310 R410 Systems By Greg Henderson, Riyad Moe, Chris Kitten and Jose L. Flores Dell™ │Datacenter Infrastructure Engineering June 2010 Cable Routing Procedures for Dell™ PowerEdge™ R310 R410 Systems THIS WHITE PAPER IS FOR INFORMATIONAL PURPOSES ONLY, AND MAY CONTAIN TYPOGRAPHICAL ERRORS AND TECHNICAL INACCURACIES. THE CONTENT IS PROVIDED AS IS, WITHOUT EXPRESS OR IMPLIED WARRANTIES OF ANY KIND. © 2010 Dell Inc. All rights reserved. Reproduction of this material in any manner whatsoever without the express written permission of Dell Inc. is strictly forbidden. For more information, contact Dell. Dell, the DELL logo, the DELL badge, and PowerEdge are trademarks of Dell Inc. Page ii Cable Routing Procedures for Dell™ PowerEdge™ R310 R410 Systems Contents Introduction 2 Section 1: Cabling a Dell™ PowerEdge™ R310 or R410 With a Cable Management Arm (CMA) 2 1.1 Connecting the CMA Cables to the System 2 1.2 Installing the Inner CMA Attachment Bracket 3 1.3 Routing the Power Cables Through the Strain Reliefs 3 1.4 Routing the Cables Through the CMA 3 1.5 Left-Side Mounting Instructions 4 1.6 Right-Side Mounting Instructions 6 Section 2: Cabling a Dell™ PowerEdge™ R310 or R410 System Without a CMA 7 2.1 Routing the Cables 7 2.2 Removing the CMA Brackets for Shallow Racks 7 Section 3: Replacing a Power Supply on a PowerEdge™ R310 or R410 System With a CMA 8 Section 4: Cabling a PowerEdge™ R310 or R410 System Installed in Static Rails 9 Table of Figures Figure 1: System with Cables Installed 2 Figure 2: Attaching the Inner CMA Attachment Bracket3 Figure 3: Routing Power Cables Through the Strain Reliefs 3 Figure 4: Routing the Cables Through the CMA 4 Figure 5: Attaching the K