alloysteelsocketsetscrews1-PrideEquipmentCorp.PDFVIP

ASTM F912 SOCKETS ALLOY STEEL SOCKET SET SCREWS1 2004e1 IFI NOTE: ASTM F912-2004e1 is reprinted with permission from the Annual Book of ASTM Standards, copyright American Society for Testing and Materials, 100 Barr Harbor Drive, West Conshohocken, PA 19428-2959, U.S.A, . 1. Scope 1.1 This specification covers the requirements for quenched and tempered alloy steel socket-set screws (SSS) 0.060 through 2.000-in. sizes having hardnesses 45 to 53 HRC. 1.2 These set screws are intended for compression applications only and are not customarily subjected to embrittlement tests. For tensile applications, consult with the manufacturer for proper alloy and hard- ness. 1.3 The hazard statement pertains only to the test method section, Section 11 of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. NOTE 1—A complete metric companion to Specification F912 has been developed—F912M; therefore, no metric equivalents are shown in this Specification. 2. Referenced Documents For a complete list of referenced standards, see the STANDARDS AND SPECIFICATION REFER- ENCE LIST on Page 1127. 3. Ordering Information 3.1 Orders for material under this specification shall include the following information: