08710.doc-DoorandHardwareSystems,Inc.docVIP

SECTION 08710 SPEC GASKETING OF DOORS AND FRAMES (3-01-04) You may find it easier to e-mail us your specification and we will e-mail it back to you with proposed changes highlighted in yellow. We will do this for any specification writer or architect for use on a standard specification or for use on a specific job. We realize specs may not include all information, however, the sections highlighted are absolutely necessary. The following specifications are in CSI format. You may need to change paragraph letters to coincide with your own sequence. You can copy and paste into a specification and then delete current references and manufacturer’s names until they show evidence of compliance. A few recommendations such as 1.04 A on substitutions are of a general nature in our recommendations. 1.02 REFERENCES: A. Documents and Institutes that shall be used in estimating, detailing and installing the items specified: 1. ANSI A117.1  Specifications for Making Buildings and Facilities Accessible to and Usable by Physically Handicapped People. CABO/ANSI A117.11999 2. NFPA 80  Fire Doors and Windows. 1999 Edition. 3. NFPA 101  Life Safety Code. 2000 Edition 4. NFPA 105  Installation of smokecontrol door assemblies 1993 Edition 5. Local and state building codes. 6. UL Labeled for Rated Doors. 7. DHI  Door and Hardware Institute. 8. SDI  Steel Door Institute. 9. AWI  Architectural Woodwork Institute. 10. UBC Standard 7-1 and 7-2(1997), IBC positive pressure where applicable. 11. UL 10 C (1998) where applicable. 12. NFPA 252 (1999) where applicable. 1.04 QUALITY ASSURANCE: Substitutions: Manufacturers and model numbers listed are to establish a standard of quality and design. The architect must approve all product substitutions. Any request for substitutions must be submitted 10 days before bid date, to allow sufficient time for addendum to be added to the bid document. In accordance with Section 016000, required data and physical samples must b