行业标准机械.doc

时间：2005-06-26 07:00 阿里巴巴－机械论坛 J 机械 　机械综合 1 GB/T 324-1988 焊缝符号表示法 Welds-symbolic representation on drawings 2 GB/T 944.1-1985 螺钉用十字槽 Cross recesses for screws 3 GB/T 1031-1995 表面粗糙度 参数及其数值 Surface rougnness--Parameters and their values 4 GB/T 1167-1996 过渡配合螺纹 The threads for transition fit 5 GB/T 1182-1996 形状和位置公差 通则、定义、符号和图样表示法 Geometrical tolerancing--Generalities,definitions,symbols,indications on drawings 6 GB/T 1184-1996 形状和位置公差 未注公差值 Geometrical tolerancing--Geometrical tolerance for features without individual tolerance indications 7 GB/T 1414-1978 管路旋入端用普通螺纹尺寸系列 General purpose screw threads for joints on pipe line--Dimensions 8 GB/T 1415-1992 米制锥螺纹 Metric tape screw thread 9 GB/T 1569-1990 圆柱形轴伸 Cylindrical shaft ends 10 GB/T 1570-1990 圆锥形轴伸 Conical shaft ends 11 GB/T 1801-1979 公差与配合 尺寸至 500mm孔、轴公差带与配合 Tolerance and fitting, dimensions up to 500mm holes, shaft tolerance range and fitting 12 GB/T 1802-1979 公差与配合 尺寸大于 500至3150mm常用孔、轴公差带 Tolerance and fitting, dimensions larger than 500mm andup to 3150mm ordinary holes,shaft tolerance range 13 GB/T 1803-1979 公差与配合 尺寸至18mm孔、轴公差带 Tolerance and fitting, dimensions up to 18mm holes, shaft tolerance range 14 GB/T 1804-1992 一般公差 线性尺寸的未注公差 General tolerances—Tolerances for linear dimensions without individual tolerance indications 15 GB/T 1958-1980 形状和位置公差 检测规定 Rules for inspection of form and position tolerances 16 GB/T 2298-1991 机械振动与冲击 术语 Mechanical vibration and shock—Terminology 17 GB/T 2358-1994 金属材料裂纹尖端张开位移试验方法 Test method for crack-tip opening displacement measurement of metallic materials 18 GB/T 2516-1981 普通螺纹偏差表 (直径1~355mm) Common screw thread deviation table 19 GB/T 3323-1987 钢熔化焊对接接头射线照相和质量分级 Methods for radiographic inspection and classification of radiographs for fusion welded butt joints in steel 20 GB/T 3505-1983 表面粗糙度 术语 表面及其参数 Surface roughness--Terminology--Surface and its parameters 21 GB/T 4096-1983 棱体的角度与斜度系列 Series of angles and slopes on wedges and prisms 22 GB/T 4133-19