耐磨涂料性能及用途.docVIP

耐磨涂料使用方法： 与新材料结合时应把新材料烘干后方可涂抹耐磨涂料3-10mm即可。 与旧材料结合时磨损部位高凹在1-15mm内可直接用耐磨涂料使用，使用时应把旧料附灰清净后用涂料专用胶涂刷一遍后即可用耐磨涂料涂抹平即可。 如果旧材料磨损部位超出15-30mm，可采用本公司生产的1﹟修补料，使用时应把旧料附灰吹净后用1﹟修补料用胶涂刷一遍后即可用1﹟修补料修补，修补留5-10mm后，再用耐磨涂料耐磨涂料专用胶抹面即可。 如果旧材料磨损部位超出30mm以上者，可采用本公司生产的2﹟修补料，使用时应把旧料附灰吹净后用2﹟修补料，专用胶涂刷一遍后即可用2﹟修补料涂抹留5-10mm后再用耐磨涂料耐磨专用胶抹面即可。 The wear-resistant coatings to use: 1, should be combined with the new material and new material after drying before smear abrasion resistant coating can be 3-10mm. 2, when combined with the old material, wear parts high concave in 1-15mm within the direct use of wear-resistant coatings, should be used with special glue of old material with ash clean with paint brushing again available after wear paint smear level that can. 3 # 1 patch material, old material wear parts beyond the 15-30mm, # 1 repair materials can be produced by our company should use old material attached cupellation net with plastic brushing again after 1 # of repair material available patch, patch, and then wear-resistant coatings for wear-resistant coating rubber hand side can stay after 5-10mm. 4, if the old material wear parts beyond 30mm or more, can be produced 2 # patch material should be used to the old material attached gray blowing # 2 repair materials, special glue brushing again available after 2 # repair The applicator to remain clean surface can be 5-10mm and then with a wear-resistant coating wear-resistant special glue. 性能： （1）耐磨涂料，特别适合用于流化锅炉耐损部位，与新旧材料粘接性强，Mpa≥3.5。（2）高温耐磨性好,cm3≤4。（3）耐火度高，1790℃。（4）不需要特殊烘炉，施工自行干燥后即可运行，不需要专业人施工技术人员，节省成本，减少施工时间，产品保质期可达5年。 Performance: (1) the abrasion-resistant coatings, particularly suitable for fluidizing boiler parts of resistance to damage, with the strong adhesive properties of the old and new materials, Mpa ≥ 3.5. (2) high temperature wear resistance, cm3 ≤ 4. (3) high refractoriness, 1790 ℃. (4) does not require a special oven, the construction itself after drying to run, do not need professional people construction and technical personnel, to