罗普斯金issue_ts022ck11n中作业类型单位的变化.docVIP

CK11N中作业类型单位的变化 作者：高林旭 一、问题现象 在使用ck11n作物料成本估算时，作业类型的单位和工艺路线中的单位、作业类型主数据的单位并不完全保持一致。 而且，该单位会随着估算的批量大小变化而变化： 批量 单位 数量 1EA MSE 11842.105 10EA MIN 1.974 100EA H 0.329 具体情况如下： 1. If costing lot size = 1EA, the activity type will be measured by MSE. And the Cost is 139.480. 2. If costing lot size = 10EA, the activity type will be measured by MIN, and the Cost is 1440.695. 3. If costing lot size = 100EA, the activity type will be measured by H, and the Cost is 14391.659. 二、问题分析 The activity type is defined with Unit “H”: And the time usage in routing is also measured by H: 三、问题原因 利用LPSK帐号提交message，SAP答复：please refer to the attached note 72442。 以下是NOTE 72442的内容： Symptom Output of units of activity types. When outputting units of activity types in the itemization in product costing or in order costing, the units are inconsistent. For example, they may be displayed in H only even though the data in the routing are all maintained in one unit, e.g. MIN. Other terms Reports: 7U0E, 7UE0, 7U0K, 7UK0, 7U0N, 7U0F CK11, CK13, CK64, CK65, line item reports, CO01, CO02, CO03, COR1, COR2, COR3, CUNI, units of measurement Reason and Prerequisites The unit of measurement used is that of the activity type, e.g. H. The system now attempts to convert all the units of measurement to H. However, there are two exceptions: 1. If the value exceeds the field size (field overflow), the next highest unit of measurement is used, e.g. TAG. 2. If the conversion causes rounding errors, to more than one thousandth, e.g. 29 MIN = 0.483333...H, the next lowest unit of measurement (in this case, MIN) used. However, note 62919 should be taken into account in this instance. The following examples show how the conversion is carried out: 2.3??H??????-?? 2.3????H 30?? MIN????-?? 0.5????H 25?? MIN????-?? 25???? MIN 29?? MIN????-?? 29???? MIN 720??SEC????-?? 0.2????H 60?? SEC????-?? 1??????MIN 59?? SEC????-?? 59???? SEC 2200 MIN????-?? 36.667 H Solution If this conversion is not required, a separate unit of m