VMready 本地组具体演示.doc

VMready Demo 1 Preparation 1.1 Topology 1.2 VMware Network Design (Hypervisor 1) vSwitch0 used for Service Console and VMware vCenter with vmnic0: vSwitch1 used for VM Network with vmnic1: vSwitch2 used for only VMhernel Network with both vmnic2 and vmnic3, so than provides high performance for vMotion 1.3 About vCenter and NAS Server vCenter installed on VM1, and VM1 used vSwitch0 NAS Server installed on VM4, and VM4 used vSwitch2 VMready Features VM Aware Adding some ports into server ports, and then Switch discovery running VMs through the Server ports By default the VMs have no VM Group membership. 2.2 VMs Communication Boundary—VM Group 2.2.1 VMs with the same VM Group Membership can communicate Example: VM2 (192.168.1.102) and VM3 (192.168.1.201) in Group 1 Set up by BBI After applied Now, VM2 and VM3 in the same group1, they can communicate each other, because the group is the boundary, only VMs in the same group can communicate. 2.2.2 Put these two VMs into different group, then they can not communicate each other 2.2.3 VM Group membership is not same with other VMs’s, but same with other VMs’s connected port Group membership, those VMs still can communicate each other VM(192.168.1.202) in VM Group 1, VM(192.168.1.102) without VM Group Two VMs can not communicate each other Put port 14 into VM Group 1 Result two VMs can communicate each other 2.2.4 If VMs at the same vSwitch, then the VMs can communicate each other even they are not in the same VM Group. 2.3 VLAN Synchronization At the beginning, all VMs without any VM Group membership, all ports of switch are belong to VLAN1 Adding VM(192.168.1.202) to Group 1 that is empty bydefault, and can see Server Port 18 is moved to VLAN 2 automatically Migrate VM(192.168.1.202) from Hypevis