江都建设项目施工方案.docxVIP

江都建设项目环氧涂装2mm Sikafloor anti-static epoxy floor2mm Sikafloor 防静电环氧地坪Used in:使用区域：Structure Profile:系统结构图：- Production area生产车间Anti-static top-coat 防静电面层 Sikafloor-262AS NConductive layer 导电层 Sikafloor 220WEarthing 接地系统Primer/scrape layer 底漆/批补层 Sikafloor-156/161Concrete 混凝土System Description:系统介绍：It’s pointed that anti-static self-levelling floor coating has very high demand to the flatness and roughnessof the substrate. If those demand cannot be met, epoxy levelling layer is needed at additional cost.需要指出的是，防静电自流平系统的施工队与基层平整度和粗糙度的要求很高，基面一定要光滑。如果平整度和粗糙度都不能达到要求，需要额外增加环氧找平层对基层进行找平。Detailed information please refer to attached datasheet of Skiafloor 156, 161, 220W, 262AS N.材料的详细技术数据及施工细节参见所附说明书 Skiafloor 156, 161, 220W, 262AS N。Application Description:施工介绍：1.Substrate Preparation 基层处理The substrate slab surface will be pre-cleaned to remove dust, dirt and any other contaminants. Thenthe whole floor will be shot blasted by blastrac blasting machine to remove surface laitance and toprovide fine roughness for good adhesion.应先对基层进行初步清理，以清除灰尘、垃圾及其他污染物，然后整个地面采用大功率进口喷砂机进行喷砂处理，除去基层表面的浮浆层，以形成微糙面来提供与后续涂层的附着力。江都建设项目环氧涂装.Primer 底漆Apply high performance solvent-free primer Sikafloor-156 to the floor by roller/trowel. If necessary,further scrape and grind the floor to eliminate substrate defects and achieve a smooth surface.用滚筒或刮板施工高性能无溶剂环氧底漆 Sikafloor-156。进一步对地面进行找补和打磨，以消除基层缺陷，并提供一个光滑的受漆面。Scrape layer 批补层When the primer is cured, repair and scrape the floor with epoxy mortar made from Sikafloor-161+quartz sand, this operation will be finished in several times.底漆固化后，使用 Sikafloor-161 和石英砂配制的环氧砂浆批补地面，这一般要分好几次完成。Earthing 接地Place self-adhesive copper tape onto conductive layer by a patter of min. 10m x 10m, then connectthem to earthing point or steel column via earthing plate.将自粘式导电铜箔以至少 10m x 10m 的间距粘贴在批补层上，然后通过导电片将其同接地点或钢柱相连。Conductive layer 导电层Apply waterbased conductive product Sikafloor-220W by rolling.滚筒施工水性导电层材料 Sikafloor-220W。江都建设项目环氧涂装6.7.Anti-static self-levelling top-coat 防静电自